OK, no, I don’t wanna chill.
It is damn cold outside (for the NW) and it is freaking chilly inside the house.
This week the low temps up here in the Northwest corner of the US is going to be in the low 20s. That isn’t typical for us so when it gets down in this range, we tend to just break out the sweatshirts and insulated jackets and try to avoid the out of doors. Last night the low was around 27 degrees.
So, the furnace has been acting funny and last night I was pretty sure there we were headed for a breakdown. Sure enough, this morning the house was 58 degrees when it should have been 66 when I got up. The furnace has in “lockout” mode – meaning it tried, it didn’t get lit, and then it gave up…for the next three hours.
When I got up to let the dog out at 5:00am I was like, “Crap. This is rather irritating, and cold. Dang, it’s cold in here.”
I tried resetting the furnace by turning off the power and then back on again. The stupid thing gave a good effort but after three cycles of trying, I gave up and went back to bed where it was warm. After warming up a bit, I was awake. So, back out of bed I went and out to build a fire in the wood stove. I was trying to be quiet so as to not wake the others in the house. Quiet, I tell you. Only to have one of the smoke detectors decide to CHIRP for a new battery. So much for being quiet.
Anyway, fire started and going and the warmth is starting to fill the room.
I called into work and let my manager know I was going to have to deal with this issue today and took at least half the day off. (Thank goodness for flexibility!)
I disassembled the ignitors, cleaned them with sandpaper, and reinstalled them. Furnace back on, cycled through the startup process, and still nothing. So, out comes the shop vac and vacuuming the pumps, the fans, the gas feed tubes (not sure of the technical term), etc. How did I know to do this stuff? I had a tech here once who we called because this happened like 6 years ago and we had no idea why it wasn’t working. He literally came out, cleaned the stuff, and charged $125 for 15 minutes of work. He was like, “Look, you don’t need me or need to pay me for this stuff. You can do it yourself.” He showed me what to look for, where to clean, and how to take the ignitors out and clean them.
Everything is back up and running. “Let there be heat!”
The fireplace is all fired up (see what I did there?) but the furnace is now doing what it is supposed to. I’ll keep the fire burning so as to not drive up the gas bill while the cold is here this week, but we are back in the warmth.